Home / Collections / Sublimation Ink and Sublimation Blanks / Semi- Gloss White Unisub Aluminum Square Magnet
Semi- Gloss White Unisub Aluminum Square Magnet

Semi- Gloss White Unisub Aluminum Square Magnet

$1.59
| /

In stock

UNISUB ALUMINUM MAGNET SUBLIMATION

Supplies needed:
- sublimatable aluminum
- sublimation transfer
- teflon or scratch paper
- heat tape
- soft paper towel (optional but recommended)

Heat press settings:
- temperature - 400 degrees F
- dwell time - 40-45 seconds
- pressure - light to medium

Note: The recommended settings above may need adjustments for best results.
Settings will vary depending on the heat press brand and model ink and paper
and atmospheric conditions.

2nd Note: The layers of soft paper towel achieve two goals: 1. it helps to
distribute the pressure evenly throughout the substrate; 2. it helps to trap
ink that is dispersed outside of the edges of the substrate if there is an
overprint area or full bleed in the artwork.

Layer the press from the bottom pad to the top heat platen as follows:
1. teflon sheet or scratch paper
2. 2-3 layers of soft paper towel (this helps distribute the pressure evenly)
3. transfer and metal
4. teflon sheet or scratch paper

Steps:
1. Place the metal face down onto the transfer face up.
2. Tape two ends of the ornament to the transfer using the heat tape.
3. Place the transfer and ornament in the press onto the paper towel (transfer
face up ornament on top of transfer face down)
4. Place the teflon sheet or scratch paper over the transfer and metal.
5. Press the items using the settings listed above.
6. Remove items from the press immediately. Use heat resistant gloves if
necessary - the items will be very hot.
7. Tear the transfer in half opposite of the taped ends.
8. Allow product to cool completely before applying magnet.

Tips:
- If the finished product appears scratched lighten the pressure slightly.
- If the image of the final product appears light increase the pressure or
the dwell time slightly (5-15 seconds).
- If the image on the final product appears blurred reduce the dwell time
slightly (5-15 seconds).
- If the metal appears to have a scratchy finished after sublimating reduce
the pressure.

Short Description:
 2.25" x 2.25" Semi- Gloss White Unisub Aluminum Square Magnet
Long Description:
 Unisub aluminum magnets will resist fading for a lasting, quality message or image. Low glare finish is scratch and finger print resistant. Magnet is self adhesive and attaches after sublimation.
Length:
 n/a"
Height:
 n/a"
Width:
 n/a"
Thickness:
 n/a
Overall Size:
 2.25" x 2.25" .045" thick
Maximum Personalization Area:
 2.25" x 2.25"
Color:
 Semi-Gloss White
Material:
 Aluminum
Gender:
 Neutral
Number of Batteries Required:
 n/a
Protective Coating:
 None